Air 802 Linux USB?ADG?2 Dokumentacja Pobierz pdf (Strona 24)

Note 3:

For a detailed description, refer to CertConvReadme.txt. (Located in

lnx_wpa_supplicant.tar.gz)

For WPA PEAP:

Network={

ssid=″example″

key_mgmt=WPA-EAP

eap=PEAP

identity=″jdoe″

password=″jdoe″

ca_cert=”/etc/cert/fluffy.pem”

phase1=″peaplabel=0″

phase2=″auth=MSCHAPV2″

priority=10

}

-After modifying, use the following command to setup WPA connection.

If the AIR802 is not yet open, then please open it first by this command:.

ifconfig eth1 up <IP address of the network interface

After the network interface is opened, enter the command to build WPA PSK connection:

./wpa_supplicant –ieth1 –c wpa_supplicant_psk.conf –d –D zydas

To build WPA EAP-TLS:

./wpa_supplicant –ieth1 –c wpa_supplicant_tls.conf –d –D zydas

To build WPA PEAP:

./wpa_supplicant –ieth1 –c wpa_supplicant_peap.conf –d –D zydas

note:

@-i: interface name: eth1

@-c: Configuration file: wpa_supplicant_pak.conf

@-D: The name of the network interface

You will see the following message is WPA-PSK connection is built successfully.

WPA: Sending EAPOL-Key 2/2 →The group handshake is about to finish.

EAPOL: SUPP_PAE entering state SUCCESS

EAP: EAP entering state SUCCESS

EAPOL: SUPP_PAE entering state AUTHENTICATED

EAPOL: SUPP_BE entering state IDLE

21



1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Brak uwag

Air 802 Linux USB?ADG?2 Dokumentacja Strona 24